Honda 00X31-TK6-6100 Owner's Manual page 151

SEEK － The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press and hold the or side of the
TUNE bar until you hear a beep,
then release it.
SCAN － The SCAN function
samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. You will see SCAN in
the display. The system will scan for
a station with a strong signal. When
it finds one, it will stop and play that
station for about 10 seconds.
Playing the AM/FM Radio (Models with navigation system)
If you do nothing, the system will
then scan for the next strong station
and play it for 10 seconds. When it
plays a station you want to listen to,
press the SCAN button again.
Preset － Each preset button can
store one frequency on AM and two
frequencies on FM.
1. Select the desired band, AM or
FM. FM1 and FM2 let you store
two frequencies with each preset
button.
2. Use the tune, seek, or scan
function to tune the radio to a
desired station.
3. Pick a preset button, and hold it
until you hear a beep.
4. Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
Each preset button's frequency is
shown on the bottom of the audio
display.
CONTINUED
145