Disassembly Procedures - Epson TM-U220 Series Service Manual

Confidential

DIsassembly Procedures

Reassembly
steps Part names
Platen release lever
(504)
Gear plate D sub
assembly (1057)
Paper feed middle gear
(509)
Paper feed middle gear
B (510)
Platen assembly 3 (522)
Platen frame (1053)
Platen rotation frame 2
(1125)
Rev. B
Assembly procedures
Remove 2 E-rings 3 (E01), and remove the platen release lever
(504) and platen shaft (1054).
Lubricate the platen shaft (1054) with G-15.
Remove 2 screws (S10), and remove the gear plate D sub
assembly (1057).
Remove 1 E-ring 3 (E01), and remove the paper feed reduction
gear 2 (1058).
Remove the paper feed middle gear (509) and paper feed
middle gear B (510).
Lubricate the gear plate D sub assembly (1057) with G-15.
Remove 1 E-ring 3 (E01), and pull out the platen shaft (1054).
In doing so, remove the paper feed middle gear B (510), the
platen release plate (1055), and the platen release lever (504)
together. Take care not to lose the platen release spring
(1056).
Remove platen assembly 3 (522).
Remove 1 screw (S09), and remove the bottom holding plate
BM (1061).
When installing the frame rotation unit (1005) on the base
frame assembly, check how to lead the autocutter unit (113)
cable. (See page 4-19.)
Remove 3 screws (S10), and remove the platen frame (1053).
After this, you can remove the platen rotation frame 2 (1125).
Lubricate the platen rotation frame 2 (1125) with G-15.
TM-U220 Type A Service Manual
Disassembly and Assembly 4-11