Installing The Wine Refrigerator; Installation; Free-Standing Installation - EdgeStar CWF340DZ Owner's Manual

3

Installing the Wine refrigerator

The wine refrigerator should be installed in accordance with local
electrical code requirements. The wine refrigerator should also be placed
in a location that is strong enough to support its total weight, keeping in
mind that it will weigh substantially more when fully loaded than when
empty.
Before you plug the wine refrigerator into a power supply, be sure to let it
stand upright for at least 24 hours to allow the compressor's oils to settle.
Unpacking the Wine refrigerator
WARNING: Use two more people to move and install the wine
refrigerator. Failure to do so can result in back or other injury. Carefully
remove the packaging materials. Remove any shipping tape and glue
from your wine refrigerator before using. Do not use sharp instruments,
rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or
glue. These products can damage the surface of your wine refrigerator.
IMPORTANT: Do not remove any safety, warning, or product information
labels from your wine refrigerator.

Installation

This wine refrigerator has been designed for free-standing installation.
There must be adequate ventilation and access for service.

Free-standing installation:

A free-standing installation will allow you to install the wine refrigerator in
almost any place you desire. You must follow the stated instructions for
electrical requirements, and leveling the wine refrigerator.

Choose a location that has ambient temperatures above 50°F and
below 95°F. Operation outside these temperatures may result in
lowered efficiency or cause other adverse effects.

This unit MUST be installed in an area protected from the
elements, e.g., wind, rain, water spray or drips.

The wine refrigerator should not be located next to ovens, grills or
other high heat sources.

Do not kink or pinch the power supply cord between the wine
refrigerator and wall or cabinet.

The wine refrigerator should be installed on a firm and level
surface that will be able to support the entire weight of a fully
loaded unit. It is important for the wine refrigerator to be level in
order to work properly. If needed, you can adjust the height of the
wine refrigerator by rotating the feet. See the "Leveling the Wine
refrigerator" section.

A standard electrical supply (115 VAC only, 60 Hz), properly
grounded in accordance with National Electrical Code and local
codes and ordinances is required.
WARNING: Do NOT install the wine refrigerator behind a closed cabinet
door