CONTENTS MAIN FEATURES PRODUCT SAFETY AND HEALTH STATEMENTS PACKAGE CONTENTS DESCRIPTION OF TRANSMITTER PARTS BUTTON FUNCTION DESCRIPTION OF COLLAR/RECEIVER PARTS BATTERY CHARGER TESTING YOUR COLLAR FITTING THE COLLAR ON THE DOG CHARGING THE BATTERIES BELT CLIP ACCESSORIES ACCESSORIES BASIC MAINTENANCE TROUBLE SHOOTING GUIDE WARRANTY AND REPAIR INFORMATION...
PRODUCT SAFETY AND HEALTH STATEMENTS Easy-to-use, ergonomic transmitter. Proper e-collar use Dogtra e-collars are intended for the sole purpose Rheostat dial allows for gradual increases in of behavior modification of dogs. They are not stimulation intensity with no jumps between intended for human use or use on other animals.
PACKAGE CONTENTS DESCRIPTION OF TRANSMITTER PARTS COLLAR DESCRIPTION OF PACKAGE CONTENTS TRANSMITTER PARTS transmitter (1-dog) Transmitter Receiver (two collar receivers for two-dog models) Antenna Battery charger and splitter cable Test light Rheostat Intensity Dial Owner’s manual ON/OFF Indicator Light Carrying case Switch (LED Window) “Nick”...
Page 5
DESCRIPTION OF TRANSMITTER PARTS DESCRIPTION OF TRANSMITTER PARTS DESCRIPTION OF TRANSMITTER PARTS transmitter (2-dog) 2 Antenna Antenna Transmitter Antenna Nick/Cont. Rheostat Toggle Switch Intensity Dial A short 2 antenna is supplied with the Indicator Light ON/OFF transmitter. (LED Window) Switch The antenna must be fastened to the transmitter before using the unit.
Page 6
DESCRIPTION OF TRANSMITTER PARTS DESCRIPTION OF TRANSMITTER PARTS Rheostat Intensity Dial LCD Screen The Rheostat Intensity Dial is located on the The LCD screen indicates the stimulation top of the transmitter: (0) being the lowest level level (0-127) on the screen. and (127) being the highest.
Page 7
DESCRIPTION OF TRANSMITTER PARTS DESCRIPTION OF TRANSMITTER PARTS Care for LCD Transmitters in Cold Temperature In cold temperatures (10 degrees F or below), the Liquid Crystal Display (LCD) on your transmitter may be dim or slow to respond. Wait until the display becomes visible before selecting any training level.
DESCRIPTION OF TRANSMITTER PARTS DESCRIPTION OF TRANSMITTER PARTS BUTTON FUNCTION (1-dog) Pager Nick Constant ON/OFF Transmitter Battery Charging Receptacle & Switch Rubber Plug Located on the backside of the transmitter, The transmitter for the the charging receptacle is covered by a rubber single dog unit has four buttons (one on the plug.
Page 9
DESCRIPTION OF TRANSMITTER PARTS DESCRIPTION OF TRANSMITTER PARTS “Constant” Button (2-dog) The “Constant” button is located on the bottom left. Pressing the “Constant” button gives Nick/Cont. continuous stimulation as long as the button is -dog Toggle Switch pushed, for up to 12 seconds. If the button is not Nick &...
DESCRIPTION OF TRANSMITTER PARTS DESCRIPTION OF COLLAR / RECEIVER PARTS the desired stimulation based on the toggle DESCRIPTION OF switch setting. COLLAR / RECEIVER PARTS When either the orange or gray stimulation button is pressed and the toggle is set on “Nick”...
Page 11
Internal Antenna recharged. (Green = full charge, Amber = medium All Dogtra E-collars have non-exposed charge, Red = needs charge) antennas that are located inside the collar/receiver. When the Constant button on the...
NOTE : Only use Dogtra-approved Chargers charged.) for your Dogtra e-collar. This will prevent 2. Place the Test light included in the package any damage that can be incurred from contents on the contact points as shown in...
The collar will reactivate when you push contact will be inconsistent and your the button again. corrections will be inconsistent also. NOTE : The test light may not luminate if the Dogtra uses Surgical Stainless Steel contact intensity level is set below level ten.
FITTING THE COLLAR ON THE DOG CHARGING THE BATTERIES CHARGING THE BATTERIES points and Anti-microbial plastic to protect the dog’s skin. ATTENTION! Avoid having the dog wear the collar for more than 8 hours out of every 24-hour period. Leaving the points on the same spot for extended periods of time can cause skin irritation.
Page 15
CHARGING THE BATTERIES CHARGING THE BATTERIES If the 3 bar indicator on the transmitter LCD 4. The battery is fully charged with a 14-hour shows just 1 bar. charge. The lights will stay red during the The indicator light on the transmitter or charging process.
RECEPTION BELT CLIP ACCESSORIES BELT CLIP ACCESSORIES Reception collar has a range of 1/2-mile. Depending on the Fig. 1. way you use your transmitter, the transmitter range may vary. Rear case Hold the transmitter away from your body and avoid touching the antenna, to get the Clip bracket greatest range.
1) Remove the clip bracket from the rear case. separately by calling our customer service at Fig.1. (888) 811-9111. You may also browse the selection at www.dogtra.com. 2) Insert the belt clip post into the clip bracket (upward as shown) and then re-tighten the bolts. Fig.1.
If you suspect your unit is malfunctioning please refer to the “Troubleshooting Guide” before you send your unit in for service. If you have any questions or concerns, you may direct your inquiries to info@dogtra.com or call (888) 811-9111.
Page 19
Heavy brush, trees, hills or You can replace them yourself by ordering moisture will affect the range of your unit. the parts from Dogtra. This is the only time For best range, hold the transmitter you should open the unit, any other vertically above your head.
The warranty will - Warranty will be voided if the unit(s) have become void and all repairs will be subject to been altered or had unauthorized service. applicable labor fees. Dogtra does not provide...
Page 21
Send repair units to: covered by Dogtra Co. within the continental United States. Any expedited shipping service will be at the owner’s expense. Dogtra is not 22912 Lockness Avenue responsible for loss of training time or Torrance, CA 90501 inconvenience while the unit is in our warehouse U.S.A.
Need help?
Do you have a question about the 1900NCP Field Star Series and is the answer not in the manual?
Questions and answers