Charging The Drive Battery - Huffy 6V Owner's Manual

Charging the Drive Battery

g g
Charger
Connector
NOTE: Before fi rst use, charge battery 15 to 18 hours.
1. Ensure power switch is OFF. Remove the seat (Refer to Seat Section) - use a
coin or screwdriver to unlock the lock in front middle of the seat.
2. Unplug the red battery connector: Push the connectors fully together, then press
in the locking clip. Then pull connectors apart.
3. Plug the charger connector into the red battery connector (Only use the 6V
charger included with the vehicle, input: AC 120V, 60Hz output: DC 6V), Plug the
charger into a standard 110V wall outlet.
4. After charging is complete (at least 8 hours, but not more than 12 hours)
5. Unplug the charger from the wall outlet.
6. Unplug the charger connector from the red battery connector.
7. Reconnect red connectors.
8. Replace Seat (see Seat section).
CAUTION: Ensure no wires or connectors are pinched under the seat when reinstall-
ing.
NOTE: The charger may feel warm during the charging. This is normal and not a cause
for concern. If excessively hot, unplug and replace.
18
y
1 1
3
3
Red battery
Connector
Red
connector
Red battery
connector
2
2