Table of Contents
Advertisement
Ofrecido por www.electromanuales.com
Turning on and setting the timer
ELECTRICAL CONNECTION
Before plugging in check that:
• the mains supply corresponds to the
power supply shown on the rating plate;
• the socket and the mains lead correspond
to the power requirements of the applian-
ce;
• the socket is suited to the plug, otherwise
have the socket replaced;
• the socket is properly grounded.
The manufactures cannot be held responsi-
ble for any damages due to failure in fol-
lowing normal safety procedures.
Replacement of the power cable must be
carried out by qualified personnel.
SETTING THE TIMER (if supplied)
16
The programmer/timer
must be set to the exact time. If for example
it is 4.00 pm. (16.00), turn the dial in a clockwi-
se direction (following the direction of the
arrow) until the number 16 is lined up with the
triangular pointer (the arrows indicates 4:00
P.M. approximately ).
20
N.B.: Never turn the dial in an anti-clockwise
direction!
The timer is in effect, an electric clock
and works only if the plug is connected to
the power supply. Whenever the plug is
disconnected or there is a power failure,
the programmer stops (the clock is then
"slow") and must be re-set.
PROGRAMMED MODE
1) Set the operating times by pushing out the not-
2) Press the TIMER key
3) Make sure that the timer indicates the cor-
4) Select the desired function as shown in the
, like all clocks,
N.B.: To override the programmed operating
times, simply press the ON/OFF key
timer signal lamp ON will go out)
pointer
ches on the dial corresponding to the period
required (each notch represents 15 mins.)
15
, the signal light
17
will come ON.
operating time
Funzionamento
rect time (see instructions on setting).
chart overleaf.
(the
15
9
Hide quick links:
Advertisement
Table of Contents
