Setting The Timer; Swing Function - DeLonghi Arctic Whisper EL Series Manual

SETTING THE TIMER

The timer allows for the delayed start up or shut down of the
appliance. This function will prevent wasting electricity by opti-
mising the operating periods.
How to program delayed shut down
• While the appliance is on in any operating mode, delayed
shut down can be programmed.
• Press the timer key (D5): the timer symbol (C7) and hours
(C6) light up.
• Press the timer key until the desired numbers of hours to
shut down appears on the display (1,2,4,6,8,12 hours).
A few seconds after the timer is set, the setting is acquired, the
display shows the operating mode and the timer symbol stays lit.
Once the set time is elapsed, the air conditioner goes into standby.
To cancel the timer program, press the timer key (D5) twice. The
timer symbol (C7) will go off.
Note: Once the timer has been activated, by pressing the timer
key only one time, the remaining hours to shut down will be
displayed.
How to program delayed start up
• Plug in the appliance and set to standby.
• Press the timer key (D5): the timer symbol (C7) and hours
(C6) light up.
• Press the timer key until the desired numbers of hours to
start up appears (1,2,4,6,8,12 hours).
When the set time is elapsed, the appliance will start to operate
in the same operating mode that was previously set.
To cancel the timer program, touch the timer key (D5) twice.
The timer symbol (C7) will go off.
NOTE: Once the timer has been activated, by pressing the timer
key only one time, the remaining hours to the start up will be
displayed.

SWING FUNCTION

The SWING button (D4) moves the flap, evenly distributing the
air into the room.
When the SWING button is pressed, the flap will begin to move
forwards and backwards alternatively.
If pressed again, the flap will be locked into its current position.
When the button is next pressed, the flap will start to move
forwards and backwards again.
Notes: in order to avoid damaging the internal mechanisms, the
flap must not be moved manually.
Notes:
•
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasona-
ble protection against harmful interference in a residential
installation.
• This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turn-
ing the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's au-
thority to operate the equipment.
• This device complies with Part 15 of the FCC Rules. Oper-
11