Connecting Wires To Terminals - Kenwood KDV-5244U Instruction Manual

Connecting Wires to Terminals

AV input
Use of the optional cable CA-C3AV
is recommended for connecting
an external player.
USB connector
(KDV-5244U/ KDV-5544U
only)
Front side
Fuse (10A)
8
7
8
7
Parking sensor wire (Light Green)
PRK SW
Parking sensor wire Junction cable
(Light Green) (Accessory3)
R
Wiring harness
(Accessory1)
TEL mute wire (Brown)
If no connections are made, do not
let the wire come out from the tab.
Power control/ Motor antenna
control wire (Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
⁄
See next page.
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
6 4 2
5 3 1
6 4 2
Connector B
5 3 1
Visual output (Yellow)
FM/AM antenna input (JASO)
Front output (KDV-5244U/ KDV-5544U only)
L
Rear output/ Sub Woofer output/ AV output (audio)
Do not connect.
To Kenwood disc changer/ External optional accessory
⁄
To connect these leads, refer to the relevant instruction
manuals.
Connect to the terminal that is grounded
when either the telephone rings or during
MUTE
conversation.
⁄
To connect the Kenwood navigation
system, consult your navigation
manual.
Connect either to the power control terminal
when using the optional power amplifier,
P.CONT
or to the antenna control terminal in the
ANT.CONT
vehicle.
For the sake of safety, be
sure to connect the parking
sensor.
⁄
Connect to the
vehicle's parking
brake detection
switch harness.
37
|
English