Dell PowerEdge T100 Series Hardware Owner's Manual page 63

Figure 3-13. Cabling a SATA Controller to the Optical Disk Drive
4
3
1 system board
3 optical disk drive
5 cable clip
10 Attach the data cable. If you are installing a SCSI tape drive, connect the
SCSI interface cable in the drive kit from the SCSI controller card to the
drive. See Figure 3-12.
11 Check all cable connections, and fold cables out of the way to allow for
airflow between the fan and cooling vents.
12 Replace the front drive bezel. See "Replacing the Front Drive Bezel" on
page 49.
13 Close the system. See "Closing the System" on page 47.
14 Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
6
5
1
2 front drive bezel
4 SATA power cable
6 SATA optical disk cable
Installing System Components
2
63