Port Connector Requirements - Cisco 7600 Series Module Manual

Chapter 1 Modules Overview

Port Connector Requirements

You need these connector types to cable to the module ports:
•
•
•
•
•
Figure 1-2
Figure 1-3
Pin 1
Pin 8
OL-9392-05
SC connectors for GBICs. (See
When you plug the SC connector into the GBIC, make sure that both the Tx and Rx
Note
fiber-optic cables are fully inserted into the SC connector.
If you are using the LX/LH GBIC with MMF, you need to install a patch cord between the
Note
GBIC and the MMF cable. Refer to the "Patch Cord" section of the Cisco 7600 Series Router
Module Installation Guide for details.
RJ-45 male connectors for the 48-port 10/100BASE-T RJ-45 module. (See
MT-RJ fiber-optic connectors for the 24-port 100BASE-FX module. (See
LC connectors for the SFP optical tranceivers installed in the Supervisor Engine 720. (See
Figure 1-5.)
RJ-21 telco connectors for the 48-port 10/100BASE-T R J-21 telco module. (See
SC Fiber-Optic Cable Connector
RJ-45 Interface Cable Connector
Figure 1-2.)
RJ-45 (both ends)
Cisco 7600 Series Router Module Guide
Port Connector Requirements
Figure 1-3.)
Figure 1-4.)
Figure 1-6.)
1-5