Table of Contents
Advertisement
SNTP section
Note: This section should not be changed.
This section allows changes to Simple Network Time Protocol parameters, if SNTP is implemented.
[SNTP]
***{ This section is optional. It is not required unless
***{ System defaults are not acceptable. Delete the
***{ single asterisks below to make this section active.
***{ This section lists user-defined client SNTP values,
***{ sync rates and an external server address.
***{
***{ Format:
(VALUES INTERNAL TO THIS UNIT)
***{
ClientMode=<mode> (act as an SNTP client)
***{
modes: 0 - Internal (default)
***{
***{
***{
***{
ServerMode=<mode> (to expose its timestamp to
***{
other units)
***{
modes: 0 - Off
***{
***{
InternalFrequency=<time frequency of sync (secs)> }
***{
-default is 600 sec (10 min)
***{
***{
(VALUES FOR EXTERNAL CONNECTION)
***{
NTPServerIPA=<IPA> of SNTP server
***{
-for Unicast mode only; optional for
***{
modes 0,2,3.
***{
ExternalFrequency=<time frequency of sync (secs)> }
***{
-default is 18000 sec (5 hrs)
***{
TZOffset=<hour> time zone offset from GMT
***{
(+,-12 in integer values)
***{
DaylightSaving=<on/off> (applies for the local
***{
time zone)
***{
on/off: 0 - off
***{
*ClientMode=1
*ServerMode=1
*InternalFrequency=600
*NTPServerIPA=192.168.200.XXX
*ExternalFrequency=18000
*TZOffset=5
*DaylightSaving=1
ERRORP section
Note: This section should not be changed.
This section allows changes to Error Log level.
[ERRORP]
ErrorLevel=3
1 - Unicast
2 - Anycast
3 - Broadcast
1 - On (default)
1 - on
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
47
Advertisement
Table of Contents
