Advertisement
-
Replacement of the power cable must be carried out by qualified personnel. Always use
original spare parts supplied by the manufacturer.
-
The heater must not be located immediately below a fixed socket outlet.
-
A safety device switches the fan heater off if it accidentally overheats.
To reset the unit for normal operation, remove the plug from the mains
socket for a few minutes, eliminate the cause of the overheating (e.g. air
intake or outlet grilles obstructed) and then plug the fan heater back in
again. Contact your nearest Technical Assistance Service if the fan heater
does not start operating normally again.
.-
Ñever direct the fan hater's air flow towards furniture, curtains , spray cans and inflam-
mable material.
Wipe your appliance with a soft damp cloth and only
when it is switched off, cold and unplugged. Do not use
solvents or abrasives detergents.
Check that there is no dust blocking the air inlet or
outlet grids. Clean using a vacuum cleaner. When not
in use remove plug from socket and store cable as
shown in Fig. 8. When not in use the heater should be
covered and stored in a dust-free place. Refer any
major maintenance to your Local Authorised Dealer.
Major servicing should be carried out every 2 - 3 years.
If in doubt refer to your nearest authorised dealer.
MAINTENANCE
Fig. 8
7
Advertisement
