Advertisement
VENTILATED RADIANT HEATER
Electrical connection
-
Before using the appliance check that your supply voltage is the same as that shown on
the rating label of the unit.
-
Connect your heater to earth provided socket only, having a capacity of at least 10/16 A.
-
THIS APPLIANCE COMPLIES WITH THE EEC DIRECTIVE 89/336 CONCERNING
ELECTROMAGNETIC COMPATIBILITY.
Operation and use
Fully insert plug into socket-outlet and switch on the fan heater following the instructions
of Fig. 7.
Before switching on the gas burner, read carefully the relevant operating instructions.
VENTILATION
ONLY
OFF
(It can be used
together with the gas
burners for an ade-
quate heat distribu-
tion).
IMPORTANT
DO NOT cover the appliance when in operation, this could cause a dangerous rise of the
temperature of the fan heater with consequent risk of fire.
Important notes
-
Your heater must always be earthed: warranty does not cover damages caused by non-
observance of this warning.
-
Do not use your heater close to wash-basin, bath- tub, shower, swimming pool.
-
Do not lay the cable on the hot unit.
-
Use the appliance only standing on the floor.
-
The heater must always operate in upright position.
-
Do not cover either the hot air output or input grid on the top of the unit during service.
6
VENTILATION + 750 W
HEATING RIGHT OR LEFT
(It can be used together with
the gas burners - 4000 W -
for the fast heating of the
room).
Fig. 7
VENTILATION
+ 1500 W
HEATING
(It can be used
together with the
gas burners - 4000
W - for the very fast
heating
of
the
room).
Advertisement
