Advertisement
- If you wish the appliance to function without programmed working period push all the notches
towards the centre.
- If your appliance comes fitted with a timer lever selector, put timer lever to position .
Once the lever has been positioned on
pre-set time periods. (Important: the plug must remain connected to power supply).
- To overide the timer, place the lever in position
- To change programmed operating times, just pull notch back to original position and reset
timer for new functioning period.
- To turn the appliance off totally, the plug must be pulled out apart from switching off, so as
to avoid unnecessary working of the timer.
d)Models with 12-hour mechanical timer
To set the delayed switching on of the appliance, switch on the appliance and select the desired
power and temperature settings as described above.
Turn the timer knob clockwise to the number of hours desired. The appliance will then
automatically switch on when this time set has elapsed.
OPTION: «TURBO» HEATER
This version of the oil filled heater is fitted with built-in fans which heat the room even faster.
A safety device switches the appliance off if it accidentally overheats. To reset the unit for
normal operation, remove the plug from the mains socket, let the appliance to cool, eliminate
the cause of the overheating (e.g. intake or outlet grille obstructed) and then plug the fan heater
back in again.
Contact your nearest Service Centre if the fan heater does not start operating normally again.
5. MAINTENANCE
Your oil filled raditor is absolutely free from maintenance, fully reliable and will give many years
of trouble free service.
Wipe heater with soft damp cloth; do not use detergents or abrasives.
In order to garantee a better suction, clean the suction grille regularly as shown in fig. 6 - 7.
6. IMPORTANT NOTES
- Your heater must always be earth connected; warranty does not cover damages caused by
non-observance of this warning.
- Do not use your heater close to bath, wash-basin, shower and swimming pool.
- Do not use your heater to dry laundry.
- Do not lay the cable on the hot unit.
- The heater must always service in upright position.
- In case of power cable replacement, only use H05VV-F 3x1 mm
- The heater must not be located immediately below a fixed socket-outlet.
- When using the appliance for the first time, switch it on for at least 2 hours with the
thermostat in the maximum position in order to eliminate the "new" smell that is
typical of all new appliances. Ensure that the room is well ventilated.
- It is normal for the appliance to emit small cracking sounds when you turn it on for the first time.
- The appliance is filled with a precise quantity of special oil, so that repairs requiring the
opening of the oil container must only be made by the manufacturer or his service agent. Any
oil leakage must be reported to the manufacturer or his service agent.
- Do not use this appliance in rooms having a floor area of less than 4 m
IMPORTANT: Do not cover the appliance during functioning, this could cause a dangerous
temperature increase of the heater; a safety device would intervene and the
appliance would no longer function. If this should occur, contact an authorized
Service Centre.
.
the heater will automatically work only during the
.
2
diameter cables.
2
.
573890/
11.96
Advertisement
