DeLonghi STRETTO Instructions Manual
Hide thumbs Also See for STRETTO:

Advertisement

STRETTO
Please retain these instructions for future reference

Advertisement

Table of Contents
loading

Summary of Contents for DeLonghi STRETTO

  • Page 1 STRETTO Please retain these instructions for future reference...
  • Page 2: General Instructions

    (fig1). Finally turn the heater over to its upright position, ensuring you do not damage the wheels. fig.1 Stretto...
  • Page 3: Installation Wall-Mounting

    4. For solid brick block walls, use a 6 mm masonry drill and drill the marked holes and then insert wall plugs to suit. (For plasterboard we suggest, locating the studding and using No 6 woodscrews directly into the wood, or special plasterboard fix- ings. For other wall types please seek specialist advice). Stretto...
  • Page 4: Electrical Connection

    - If using more than one appliance at a time, it is important to ensure that the ring main is adequate to cope with the power requirements. - It is important to ensure that the socket is adequately earthed. - This appliance complies with EEC directive 89/336 regarding electromagnetic compatibility. Stretto...
  • Page 5: Adjusting The Thermostat

    N.B.: Never turn the dial in an anti-clockwise direction! The timer is in effect an electric clock and works only if the plug is connected to the power supply. Whenever the plug is disconnected or there is a power failure, the clock must be re-set. Stretto...
  • Page 6: Cleaning And Maintenance

    (this should take around 30 minutes). It is sufficient to remove external dust with a soft, dry cloth. Never use abrasive powders or solvents. If necessary, remove concentrated areas of dirt with a vacuum cleaner. Stretto...
  • Page 7 The appliance is fitted with a safety device which will switch off it in case of accidental overheating.To reset, contact an authorised service centre. IMPORTANT: never for any reason cover the appliance during operation as this could lead to dangerous overheating Stretto...
  • Page 8 Always state this colour when ordering a replacement fuse cover. Only 13amp replacement fuses which are asta approved to B.S. 1362 should be fitted. This appliance conforms to the Norms EN 55014 regarding the sup- pression of radio interference. Stretto...
  • Page 9 5706000500/ 01.04...

Table of Contents