Advertisement
MAINTENANCE
Always pull the plug out of its electrical outlet before beginning any cleaning.
This electric convector requires no special maintenance. All you have to do is dust it off with a soft,
dry cloth — but do so only when the appliance is cold. Never use abrasive powders or solvents.
HELPFUL ADVICE
Important: to avoid the safety system resetting accidentally, this appliance must not be powered
through an external timer.
• The first time you use the appliance, operate it for at least 15 minutes with the thermostat at maxi-
mum to eliminate the "new" smell. A little smoke due to the protective substances applied to the
heating element before transport may be given off.
• Do not use the convector heater near bath tubs, showers, sinks or swimming pools. The appliance
must not be placed directly under a fixed socket.
• Do not rest the power cable on the appliance when hot.
• Always use the heater in a vertical position only.
• Do not obstruct the hot air outlet grilles or the air intake grille on the bottom of the appliance.
• This appliance is not intended for use by persons (including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning the use of the appliance by a person responsible for their
safety. Young children should be supervised to ensure that they do not play with the appliance.
• If the power cable is damaged, it must be replaced by the manufacturer, an authorised service cen-
tre or a qualified electrician in order to eliminate all risk.
• Do not use this appliance in rooms measuring less than 4m
currents of air which could disturb operation of the heater.
A safety device trips and turns the appliance off in the event of overheating or if it is placed in
strong currents of air. To reset, unplug the appliance from the mains socket and leave to cool down
(about five minutes), remove the cause of overheating, plug back into the mains and turn on again.
WARNING: In order to avoid overheating, never under any circumstances cover the applian-
ces during operation.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this applian-
ce must not be supplied through an external switching device, such as a timer, or connected to a cir-
cuit that is regularly switched on and off by the utility.
4
2
. You should avoid positioning it in
Advertisement
