Using Peap In Vista; Figure 45 Vista Security: Additional Information Required; Figure 46 Vista Security: Enter Credentials - ZyXEL Communications NWD271N User Manual

Chapter 4 ZyXEL Utility - Windows

4.7.1 Using PEAP in Vista

Take the following steps to set up WPA, WPA2 or 802.1x security using PEAP in Windows
Vista.
1 Either select the AP to which you want to connect in the Site Survey screen (see
4.4 on page
2 In the WPA, WPA2 or 802.1x security screen (see
Section 4.4.1.4 on page
and Password fields are greyed-out (not available).
3 Click Next.
4 In the Summary screen that appears, click Save.
5 A message similar to the following appears in the bottom-right of your screen. Click the
message.

Figure 45 Vista Security: Additional Information Required

6 The Enter Credentials screen displays. Enter your User name and Password for the
network to which you want to connect.

Figure 46 Vista Security: Enter Credentials

If you are not sure what to enter, contact your network administrator.
7 Click OK. The Enter Credentials screen disappears and the NWD271N tries to connect
to the network. The ZyXEL utility's Link Info screen displays, showing the connection
status (see
connection, you have successfully completed the procedure.
68
53), or configure a profile in the normal way (see
57), select PEAP as the EAP Type. Note that the Login Name
Section 4.3 on page 51). If the Link Info screen displays an active
Section 4.5 on page
Section 4.4.1.3 on page 56
NWD271N User's Guide
Section
59).
and