Toner Replacement Process - Sharp MX-7000N Manual

Routine Maintenance

Toner Replacement Process

The overall maintenance of the Sharp MX-7000N is
straightforward and simple. Most users will find the direc-
tions easy to use. The toner bottle design ensures that
the toner cannot be placed in the incorrect slot. Both the
high-capacity tandem black toner and colour toners can be
replaced while the device is still printing. When a toner level
is low, a warning message appears on the touch screen.
The user can change the toner at this point or wait until the
toner is empty to replace it.
Refilling the toner is extremely simple and clean. The
colour toner and two black toner bottles are located in the
front main door, which opens down (Figure 1).
The bottles are horizontally spaced across the front of
the device. Each bottle is equal in size and has a colour-
coded top. (Figure 2)
To change the toner, the empty bottle is pulled out. To
replace the toner, the user lines up the arrow on the top of
the bottle, pulls off the adhesive strip, and then replaces the
toner into its correct slot (Figure 3).
Copyright © 2006 MCA Internet, LLC dba BERTL. All Rights Reserved. The license under which this document is made available and applicable law prohibit any reproduction or further transmission of any
E x c e p t i o n a l
portion of this document. This document may only be viewed electronically through the www.BERTL.com Web site and may not be stored in electronic or hard copy format. Any reproduction of trademarks is
strictly prohibited. BERTL accepts no responsibility for any inaccuracies or omissions contained in this document.
Office
Figure 1
Figure 2
Figure 3
Back to Contents
Sharp MX-7000N
page 14 • September 1, 006