Wlan Settings - Nokia E72 User Manual

WLAN network mode
determined by the settings of its access point device.
Network status — Define whether the network name is
•
displayed.
WLAN network mode
•
hoc network, and to allow devices to send and receive data
directly; a WLAN access point device is not needed. In an
ad hoc network, all devices must use the same WLAN
network name.
WLAN security mode
•
802.1x, orWPA/WPA2. (802.1x and WPA/WPA2 are not
available for ad hoc networks.) If you select
network, no encryption is used. The WEP, 802.1x, and
WPA functions can be used only if the network supports
them.
Use access point — Select
•
device to ask for confirmation before the connection using
this access point is created or
device to connect to the destination using this access point
automatically.
To enter the settings for the selected security mode, select
WLAN security settings.
Advanced WLAN settings
Select Options Advanced settings
>
following:
IPv4 settings — Enter the IP address of your device, the
•
subnet IP address, the default gateway, and the IP
addresses of the primary and secondary DNS servers.
Contact your internet service provider for these addresses.
IPv6 settings — Define the type of DNS address.
•
Ad-hoc channel (only for ad hoc networks) — To enter a
•
channel number (1-11) manually, select
50
and WLAN security mode
— Select Ad-hoc to create an ad
— Select the encryption used: WEP,
Open
After confirmation
Automatically to set the
and from the
User defined.
are Proxy server address
•
server.
Proxy port number
•
Packet data (GPRS) settings
Select Menu
Packet data.
Your device supports packet data connections, such as GPRS
in the GSM network. When you are using your device in GSM
and UMTS networks, it is possible to have multiple data
connections active at the same time; access points can share
a data connection, and data connections remain active, for
example, during voice calls.
to set the
To define the packet data settings, select
connection
the packet data network when you switch the device on in a
supported network, or
to a packet data network only when an application or action
attempts to establish a packet data connection. This setting
affects all access points for packet data connections. To use
the device as a packet data modem for your computer, select
Access point, and enter the access point name provided by
your service provider. To use a high-speed data connection,
select High speed packet access

WLAN settings

Select Menu
Wireless LAN.
To have an indicator displayed when there is a wireless LAN
(WLAN) available in your current location, select
availability
— Enter the address for the proxy
— Enter the proxy port number.
Ctrl. panel Settings
> >
and When available to register the device to
When needed
> Enabled.
Ctrl. panel Settings
> >
> Yes.
and Connection
>
Packet data
to register the device
and Connection
>
Show WLAN