Wlan Settings - Nokia E52 User Manual

Use access point — Select
•
device to ask for confirmation before the connection using
this access point is created or
device to connect to the destination using this access point
automatically.
To enter the settings for the selected security mode, select
WLAN security settings.
Advanced WLAN settings
Select Options Advanced settings
>
following:
IPv4 settings — Enter the IP address of your device, the
•
subnet IP address, the default gateway, and the IP
addresses of the primary and secondary DNS servers.
Contact your internet service provider for these addresses.
IPv6 settings — Define the type of DNS address.
•
Ad-hoc channel (only for ad hoc networks) — To enter a
•
channel number (1-11) manually, select
Proxy server address
•
server.
Proxy port number
•
Packet data (GPRS) settings
Select Menu Ctrl. panel
>
Packet data.
Your device supports packet data connections, such as GPRS
in the GSM network. When you are using your device in GSM
and UMTS networks, it is possible to have multiple data
connections active at the same time; access points can share
a data connection, and data connections remain active, for
example, during voice calls.
© 2010 Nokia. All rights reserved.
After confirmation
Automatically
and from the
User defined.
— Enter the address for the proxy
— Enter the proxy port number.
Settings and Connection
>
to set the To define the packet data settings, select
connection
the packet data network when you switch the device on in a
to set the
supported network, or
to a packet data network only when an application or action
attempts to establish a packet data connection. This setting
affects all access points for packet data connections. To use
the device as a packet data modem for your computer, select
Access point, and enter the access point name provided by
your service provider. To use a high-speed data connection,
select High speed packet access

WLAN settings

Select Menu
Wireless
To have an indicator displayed when there is a wireless LAN
(WLAN) available in your current location, select
availability
To select the interval for your device to scan for available
WLANs, and to update the indicator, select
networks. This setting is not available unless you select
Show WLAN availability
To set the device to test the internet capability of the selected
>
WLAN automatically, to ask for permission every time, or to
never perform the connectivity test, select
connectivity test
or Never
test to be performed when the device asks for it, and the
connectivity test is performed successfully, the access point
is saved to internet destinations.
and When available
When needed
Ctrl. panel Settings
> >
LAN.
> Yes.
> Yes.
Run automatically,
>
run. If you select Run automatically
Packet data
to register the device to
to register the device
> Enabled.
and Connection
>
Show WLAN
Scan for
Internet
Ask every time,
or allow the
143