Resetting The Ip Camera; Cleaning The Ip Camera - Cisco CIVS-IPC-2611 User Manual

Resetting the IP Camera

To power off the IP camera, take either of these actions:
•
•
Resetting the IP Camera
You can reset the IP camera by disassembling it and pressing the Reset button on the camera unit (see
Figure 1-2 on page
There are various reset types, as described in
You also can perform some reset operations from the Maintenance window as described in the
"Maintenance Window" section on page
Table 2-1
Reset Type
Reboot.
IP address reset.
Factory reset.

Cleaning the IP Camera

To clean and IP camera, follow these guidelines:
•
•
Cisco Video Surveillance 2611 IP Dome User Guide
2-12
If the IP camera is receiving PoE, disconnect the network cable
If the IP camera is receiving power through the power adapter, unplug the adapter from the wall or
disconnect it from the camera
1-5).
Resetting the IP Camera
To clean components, use a clean, dry, soft cloth to gently wipe the components. Do not use liquid
cleaners on the dome assembly, except for cleaners that are designed specifically for optical-grade
acrylic.
To clean the lens, use only tissue paper or solution that is designed for high quality optical lenses.
Table 2-1.
3-14.
Procedure
Press and immediately release
the Reset button.
Press and hold the Reset button
for at least 1 second but no more
than 9 seconds.
Press and hold the button for at
least 10 seconds.
Chapter 2 Getting Started
Remarks
This action is equivalent to
powering the IP camera down
and then powering it up. Settings
that are configured for the IP
camera are retained.
If DHCP is enabled in your
network, the IP camera obtains
an IP address from the DHCP
server. Otherwise, after 90
seconds, the IP camera IP
address resets to the default
address of 192.168.0.100. All
other configuration settings are
retained.
Sets all IP camera options to
their default values. After you
perform this procedure, follow
the steps in the "Performing the
Initial Setup of the IP Camera"
section on page 2-7.
OL-24128-02