Using The Platinum Series Sound Processor; Getting Started - Quick Steps - Advanced Bionics Platinum Series User Manual

Using the Platinum Series Sound Processor

Getting Started – Quick Steps
In order to use your processor, follow the steps below:
1. Verify that the processor program switch is in the off position (o).
2. Check that a charged battery or an AA battery pack has been correctly inserted
onto the processor.
3. Adjust the volume (
way to the left.
4. Check the position of the sensitivity control (
on the control is at the 12:00 position.
5. Check that the headpiece connector is properly plugged into the headpiece
jack on the processor.
6. Place the headpiece on your head over the implant.
7. Turn the processor on by turning the program switch to the appropriate position
(as determined by your audiologist). Note that the red LED indicator should
blink 1-4 times to indicate the battery charge status.
8. Verify that the red LED indicator on the processor stops fl ashing once successful
communication or "lock" is established with the implant.
9. Readjust the volume and sensitivity controls as necessary. Adjustment of the
controls may vary throughout the day depending upon the listening environment.
WARNING: While no injury cases have resulted, components of the system may
become hot during normal use or a fault condition. If a particular
device's temperature results in discomfort or pain, promptly remove
the product and contact your local AB representatives.
IMPORTANT: Use only the processor that has been programmed especially for you.
Using a different processor, which has been loaded with a different
program, may be ineffective in providing sound information or
may cause physical discomfort.
Be sure to turn the processor off before removing the headpiece.
NOTE: Under limited circumstances, the cochlear implant system may
cause interference with TV reception. Based on internal testing and
fi eld experience, there is no evidence that this interference causes
safety-related hazards. Consult your programming center or AB for
assistance.
) so that the indicator notch on the control is all the
User Guide for the Platinum Series Sound Processor 25
) so that the indicator notch