Installing The Driver Software - Microtech USB XpressSCSI User Manual

USER'S
USER'S
MANUAL
MANUAL

Installing the Driver Software

Macintosh Installation (Mac OS 8.5 or above):
1.
Insert the Microtech Installer CD-ROM
2.
Double-click on the "Microtech Installer" Icon
3.
Follow any instructions displayed on the screen.
4.
After installing the driver software, finish reading this chapter and connect the USB
XpressSCSI to your computer. For instructions on connecting the USB XpressSCSI
directly to your computer proceed to the section "Connecting to the USB Port" (page 16).
For instructions on connecting to a USB hub, proceed to the section "Connecting to a
USB Hub"(page 17).
Installation note: If you attempt to attach the USB connector to the USB port of your
Macintosh or hub prior to installing the USB XpressSCSI drivers you may receive the following
(or a similar) message:
If this occurs, click "OK", install the driver software, and then attach the USB connector. For
more information on attaching USB devices proceed to the section "Connecting to the USB Port"
(page 16) or "Connecting to a USB Hub" (page 17).
15
?
HELP
CONTENTS
USB XpressSCSI
BACK
CONTACT
NEXT