Vizualogic RoadTrip RT-043A Manual page 13

Rear view mirror with gps
Hide thumbs


Table of Contents
Bluetooth ON: Choose
to choose if you want the Bluetooth to remain connected.
Auto Answer: Choose
to choose if you want the Bluetooth device to answer all incoming calls
Pairing code:
Enter a 1 8 digit code for pairing your phone, after you enter the code you should get a
prompt on your mobile phone display to enter the pairing code. After you receive this message pair
your phone with the same code you entered into the mirror.
The pairing code is a safety passkey to protect your personal information. Pair both devices with the
same passkey. The passkey is a 1 8 digit code.
3) Pair with the cell phone
For the first time the user is required to enter the same PIN code on both devices. Once you have
entered the PIN code , both devices will generate a link key. The link key can be stored either in the
devices themselves or in a permanent storage. Next time both devices will use a previously generated
link key. The procedure above is called pairing. Note that if the link key is lost by any device, then pairing
must be repeated. For safety, the Bluetooth will not communicate until paired.
Click (pairing) on the Bluetooth interface to pair, now the device is in discoverable mode. The system
will go back to the Bluetooth interface if the device is not connected within 60 seconds.


Table of Contents

  Related Products for Vizualogic RoadTrip RT-043A

Table of Contents