Checking Battery Power; System Resets - Honeywell Dolphin 7800 User Manual

MedState=25%
This sets the Low Battery point to 25%. When the battery hits the percentage charge specified
here, the user is notified.
LowState=10%
This sets the Critical Battery point to 10%. When the battery hits the percentage charge
specified here, the user is notified.
Note: Warnings do not appear when the terminal is on external power.
Setting Critical and Low Battery Points
Developers can reset the battery parameters in the registry from 0 (no warning) to 99 (would nearly
always warn). You can review and set these battery points in the RegEdit Power Tool.
1. Tap > Power Tools > RegEdit.
2. Drill down to HKEY_LOCAL_MACHINE > ControlPanel > Power.
3. Tap the Value Name to change the Value Data.
You can reset the Value Data from 0 (no warning) to 99 (would nearly always warn).
4. Tap OK to save changes.
For more information about the RegEdit Power Tool, refer to the Dolphin Power Tools User's Guide avail-
able for download at www.honeywellaidc.com.

Checking Battery Power

1. Tap > Settings > System
2. Tap Power to view the power status of the main battery and backup battery.
Note: The Backup Battery gauge registers either 0% or 100%. The percentage is not an indication of the level
of charge remaining on the backup battery. An installed and functional battery registers 100%. A total
discharge or a battery error registers 0%.
Or
Tap Battery to view detailed information on the installed battery pack.
For additional information on Advanced Power Settings,
For additional information on the Battery Log Configuration,

System Resets

See Resetting the Terminal on page 2-11.
see page 7-15.
see page 7-10.
3 - 15