Charging The Main Battery; To Power A Terminal And Charge Its Main Battery; Mounting The Chargebase - Honeywell Dolphin 7800 User Manual

Charging the Main Battery

The base provides power to the Dolphin terminal(s) and
allows charging of the main batteries in the terminals. The
main battery of each terminal charges in 4 hours for the
standard battery or 6 hours for the extended battery. The
intelligent battery charging system incorporated into all
Dolphin terminals prevents overcharging, which means that
Dolphin terminals may be seated in the base indefinitely
without damage to the terminals, battery packs, or the base.
For more information about Honeywell battery packs and
how to check battery power levels in your terminal, refer to
Power (page 7-15) and

To Power a Terminal and Charge its Main Battery

1. Install the main battery pack in the terminal; see
2. Verify the base has power. If the Power/Dock LEDs are not illuminated, see
the ChargeBase on page
3. Slide the Dolphin terminal into one of the four terminal wells. The Power/Dock LED for the well
changes to green. Charging begins immediately if required by the Dolphin terminal.
Ensure all components are dry prior to mating terminals/batteries with peripheral devices. Mating wet
components may cause damage not covered by the warranty.
We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may result in
damage not covered by the warranty.

Mounting the ChargeBase

This base should be mounted to a dry, stable surface. When choosing a location, always bear in mind
that:
• The mounting location must allow users easy access to the power connector.
• The base should be oriented so that users can easily see the LEDs.
Bottom Panel
DIN Rail Slot
Mounting Holes for Wall
Mount Bracket Hardware,
Qty. 4
15 - 4
Batteries (page 3-12).
15-3.
Install the Main Battery Pack on page 2-1.
Connecting Power to
Rubber Feet, Qty. 8