Connecting The Speaker Cables; Connections; Connecting The Speakers - Denon CEOL RCD-N8 Owner's Manual

Connections

NOTE
• Do not plug in the power cord until all connections have been
completed.
• When making connections, also refer to the operating instructions of
the other components.
• Be sure to connect the left and right channels properly (left with left,
right with right).
• Do not bundle power cords together with connection cables. Doing
so can result in humming or noise.
Cables used for connections
Audio cable (sold separately)
Subwoofer cable
Speaker cable
Optical cable
L
Audio cable
R
Stereo mini-plug cable

Connecting the speakers

Speakers
(L) (R)
w q w q
L
R

Connecting the speaker cables

Carefully check the left (L) and right (R) channels and + (red) and –
Subwoofer
(black) polarities on the speakers being connected to this unit, and be
with built-in
sure to interconnect the channels and polarities correctly.
amplifier
1
Peel off about 10 mm of sheathing from
the tip of the speaker cable, then either
IN
twist the core wire tightly or terminate it.
2
Turn the speaker terminal
counterclockwise to loosen it.
3
Insert the speaker cable's core wire to
the hilt into the speaker terminal.
4
Turn the speaker terminal clockwise to
tighten it.
NOTE
• Disconnect this unit's power plug from the power outlet before
connecting the speakers. Also, turn off the subwoofer.
• Use speakers with an impedance of 4 to 16 Ω. The protection
circuit may be activated if speakers with an impedance other
than specified are used.
• Connect the speaker cables so they do not stick out of the
speaker terminals. The protection circuit may be activated if the
wires touch the rear panel or if the + and – sides touch each
other
• Never touch the speaker terminals while the power supply is
connected. Doing so could result in electric shock.
6
(vpage 59 "Protection circuit").