Troubleshooting - Denon CEOL RCD-N8 Owner's Manual

Troubleshooting

If a problem occurs first check the following:
1. Are the connections correct?
2. Is the set being operated as described in the owner's manual?
3. Are the other devices operating properly?
If this unit does not operate properly, check the items listed in the table below. If the problem persists,
there may be a malfunction.
In this case, disconnect the power immediately and contact your retail outlet.
GGeneralH
Symptom Cause
Set does not • External noise or interference is
operate properly. causing the set to malfunction.
Display not lit • Power cord not plugged in
and sound not securely.
produced when
power switched
to on.
Display lit but
• The speaker cables are not
sound not
properly connected.
produced.
• The function is not switched to
the input source you want to
play.
• The volume is set too low.
Display is off. • The Dimmer setting is set to
"Off".
For stereo • The connections of the speaker
sources, the cables or input cables
positions of the inverted.
instruments are
inverted.
Power turns off • Set is damaged.
suddenly and
POWER indicator
flashes red.
(Flashes at 0.25
second intervals)
"No Network • The network is not properly set
Connection" is up.
displayed.
Countermeasure Page
• Reset the microprocessor.
• Check the connections on
the set's rear panel and the
connection of the power plug to
the power outlet.
• Connect securely.
• Switch to the correct function.
• Adjust the volume to an
appropriate level.
• Set to something other than
"Off".
6
• Check and remedy the
are connections.
• Turn off the power and contact a
DENON service center.
• Select a source other than the
network function.
Quick setup
• Perform "Quick Setup".
guide
GCDH
Symptom
"Unsupported" • The disc is not properly loaded.
is shown on the
display even
though a CD is
loaded.
Disc does not • The disc is dirty or scratched.
1/3
play when
button is pressed.
49
A specific part • The disc is dirty or scratched.
of a disc is not
10 played.
A CD-R or CD-RW • The disc has not been finalized.
disc cannot be • The recording conditions are bad
played. or the quality of the disc itself
it poor.
6
MP3 and WMA • The file formats, extensions or
files cannot be settings made when the disc
23
played. was created are not compatible
with this unit.
23 GTunerH
Symptom
24
Continuous noise • Antenna cable is not properly
is heard when connected.
– 10
receiving FM
programs.
–
23
61
Cause Countermeasure
• Reload the disc.
• Wipe the disc clean or replace
the disc.
• Wipe the disc clean or replace
the disc.
• Finalize the disc then play it.
• Use a properly recorded disc.
• Create discs with file formats,
extensions or settings
compatible with this unit.
Cause Countermeasure
• Connect the antenna cable
properly.
• Connect an outdoor antenna.
Page
3
3
3
3
–
56
Page
8
–