Denon CEOL RCD-N8 Owner's Manual page 22

5
If there is an encryption setting for the access point
you selected in step 4, enter same encryption key as
used for the access point. (If there is no encryption
setting, proceed to step 6.)
uio p 0 – 9 +10
Use or , to input the "Password" (encryption
ENTER
key) and press or p. Enter the same encryption key as
used for the access point.
• The types of characters that can be input are as shown below.
GLower case charactersH
abcdefghijklmnopqrstuvwxyz
GUpper case charactersH
ABCDEFGHIJKLMNOPQRSTUVWXYZ
GSymbolsH ! " # $ % & ' ( ) z + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | } ˜
GNumbersH 0123456789 (Space)
• When no security settings have been used in the Internet
connection settings, this step is not necessary.
6
i
Use to select "Test Connection", then press
or p .
"Wait for the network to connect..." is displayed, and the unit
starts connecting to the network.
• This unit performs automatic network setup due to the DHCP
function.
n WPS Settings (Push-button method)
By just pressing the WPS button on your router and this unit, the
wireless LAN connection settings are made.
• Before turning this unit on, make sure that an Ethernet cable is
not connected to this unit. If a cable is connected, have this unit
enter the power standby mode and disconnect the cable.
• After the unit is turned on, it takes approximately 30 seconds for
the WPS button on this unit to be available.
1
Press the WPS button of the router.
2
WPS
Press on the rear panel.
"Wait for the network to connect..." is displayed, and the unit
starts connecting to the LAN.
ENTER
• When the connection is made successfully, "Connected!" appears.
• If the connection cannot be established, "Connection Failed" is
displayed. Perform steps 1 – 2 again.
NOTE
If the router uses WEP, WPA-TKIP or WPA2-TKIP encryption,
connection is not possible using the
using "Auto-scan" or "Manual".
n WPS Settings (PIN code method)
1
2
3
4
WPS
button. In this case, connect
19
Setting the network [Network]
Press SETUP .
Turns on the Menu settings mode
and the Menu appears on the display
(vpage 11 "Menu map").
TOP MENU
Use ui and ENTER to select
"Network" – "Settings" – "WPS
(Wi-Fi Protected Setup)" – "PIN
SEARCH
ENTER p
code", then press or .
The access point that you have set is
displayed.
ui
Use to select the access point
whose PIN code you want to
ENTER p
display, and press or .
PIN code number is displayed.
Set this PIN code to the register.
When connection is established with
"Connected!" is displayed.
INTERNET ONLINE MUSIC
RADIO MUSIC SERVER
TUNER ANALOG IN DIGITAL IN
iPod USB CD
CH - CH +
TUNE - TUNE +
MUTE
ADD
FAVORITE VOLUME
SDB
CALL
TONE
INFO
ENTER
SETUP
1 2 3
. / ABC DEF
4 5 6
GHI JKL MNO
7 8 9
PQRS TUV WXYZ
+10 0
CLEAR
a/A *
RANDOM REPEAT PROGRAM MODE
RC-1174
access point,