Pride Mobility Jazzy Select 14XL Owner's Manual page 23

V . C O M F O R T
To adjust the seatback angle:
1. Remove the adjusting screws from each seat hinge. See
figure 13.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screws to each seat hinge and tighten.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat, you
can adjust the seatback angle with the seatback release le-
ver. The lever is located on the right side of the seat base.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or backwards to the desired position.
3. Release the lever.
Armrest Width Adjustment
You can change each armrest's width independently of the
other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the arm-
rest receiver bracket. See figure 13.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Height Adjustment
To change the armrest height:
1. Loosen the setscrews on the armrest. See figure 13.
2. Raise or lower the armrest to the desired height.
3. Tighten the setscrews to secure the armrest.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to
the floor. See figure 13.
2. Loosen the jam nuts.
3. Turn the adjusting screw clockwise to lower the front
of the armrest, or turn the adjusting screw counterclock-
wise to raise the front of the armrest.
4. Tighten the jam nuts to lock the adjusting screw into
place.
Jazzy Select 14XL
A D J U S T M E N T S
ARMREST
ANGLE
ADJUSTING
SCREW
JAM NUTS
SEATBACK ANGLE
ADJUSTING
SCREW
ARMREST KNOB
Figure 13. Armrest and Seatback Adjustments
www.pridemobility.com
SETSCREWS
SEAT
HINGE
23