Pride Mobility Jazzy Select 14XL Owner's Manual page 21

Seat Installation
It may be necessary to install the seat either prior to initial
operation or after transporting your power chair.
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot,
and you may lose control of the seat if
they do so, resulting in personal injury
or damage to the chair.
To install the seat:
1. Set the seat on the seat tower. See figure 10.
2. Push the seat down until the latch engages.
3. Install the controller and route the cable to the back
of the power base. See figure 11.
4. Plug the charger inhibit connector and the controller
connector into the power base. See figure 6.
NOTE: The charger inhibit connector is coded with
colored dots. The dots are positioned so that the flat
side of the male connector aligns with the flat side of
the female connector while making the connection.
WARNING! Failure to properly align the
connectors can result in damage to the
controller, the charger, the charger har-
ness, and the connectors.
5. Secure the controller cable to the armrest receiver
with wire ties. See figure 11.
Jazzy Select 14XL
I V . A S S E M B L Y
www.pridemobility.com
Figure 10. Seat Installation
Figure 11. Cable Routing
SEAT
TOWER
21