NEVER connect the unit to an AC outlet or to a DC power for the FP-561 MARINE PLOTTER/SOUNDER and RD-200 supply that uses more than 33 V (FP-561) or 16 V (RD-200). DGPS BEACON RECEIVER at the time of publication.
Page 4
SECTION 1 SPECIFICATIONS 1-1 FP-561 ‘ GENERAL • Display : 5.6 inch TFT color LCD (320 234 pixels) • Power supply requirement : 11–30 V DC • LCD brightness : 16 levels • Power consumption : Less than 22 W (Less than 1.8 A at 12 V DC) •...
Page 5
‘ VIDEO SOUNDER • Transmission freq. : 50 kHz, 200 kHz • Output power : 500 W RMS • Water depth range : 5–640 m* in 8-color indication • Water temp. range : 0˚C to +40˚C; +32˚F to +104˚F • Speed range : 0.0–99.9 KT* •...
SECTION 3 CIRCUIT DESCRIPTION 3-1 TRANSMITTER CIRCUITS 3-1-4 DIODE ISOLATION CIRCUIT D3, D30, D4, D31, D9, D32, D35, D36 are symmetry-type sil- 3-1-1 TRANSMIT OUTPUT PULSE CONTROL licon-varister diodes. Interior connection is simulated as CIRCUIT shown in the diagram (Fig.1). The 200 kHz/50 kHz pulse signals from the LOGIC unit via J1 (pin 3) are passed through the buffer amplifier circuit (IC1, Fig.2 shows the diode’s electronic characteristics.
3-2-2 STC CIRCUIT 3-2-5 LOCAL OSCILLATOR CIRCUITS The STC circuit (Q1, R115, Q26, R116, C102) reduces the 200 kHz/50 kHz local oscillator circuits consist of IC3, X1 and sensitivity near-by the dispach line to set the immunity to air IC4, X2 respectively. IC3 or IC4 includes a frequency divider. bubbles in the sea surfaces so as to improve the image leg- When high level signal is applied to pin 1, IC3 or IC4 oscil- ibility.
3-3-4 SWITCHING CIRCUIT 3-4-3 DGPS INTERFACE CIRCUIT IC9 (pins 9 and 10) controls the switch circuit (Q14, Q16), • DGPS INPUT CIRCUIT and the primary winding of transformer (T2) is alternately DGPS input circuit consists of IC7, IC15. The DGPS signals connected to and disconnected from the DC power.
3-7 PORT ALLOCATIONS fier (IC1) and are then enter another low-pass filter (L6, L7, C15–C19) and notch filter (L24, L25, C111, C112) to sup- 3-7-1 FP-561 press unwanted signals. The filtered signals are applied to • SUB CPU (LOGIC UNIT; IC22) the mixer circuit.
Page 12
FP-561 • MAIN CPU (LOGIC UNIT; IC1) Port Description number name DTCK Outputs serial clock signal for the LCD. Outputs vertical synchronizing signal VSYNC for LCD. Outputs horizintal synchronizing signal HSYNC for LCD. Outputs red color signal for LCD. BLUE Outputs blue color signal for LCD.
Output level : 0.1 µV–32 mV generator (SSG) Frequency range : At least 10 MHz (–127 to –17 dBm) Spectrum analyzer Spectrum bandwidth: ±100 kHz or more ‘ ‘ CONNECTION FP-561 EX-1622 Marine Transom- Ploter/Sounder type transducer (Option) Ground EX-1010...
• Set an SSG as : Frequency : 50 kHz Level : 100 mV (–7 dBm) *This output level of the standard signal generator (SSG) is indicated as SSG’s open circuit. 4-4 FP-561 WATER TEMPERTURE ADJUSTMENT ADJUSTMENT MEASUREMENT POINT ADJUSTMENT ADJUSTMENT CONDITION...
Page 15
• MAIN unit RSSI Receive sensitivity check point Receive sensitivity adjustment Pin 3 Output power check point J2 Pin 5 Pin 6 Water temperature pre-setting J2 Pin 7 • LOGIC unit R131 Water temperature adjustment 4 - 3...
7.29920 MHz MAIN to the FP-561’s DGPS connector cy counter to the FREQUENCY and turn FP-561 power ON. check point “CP1”. • Set the connected FP-561 as: Connect a SINAD 25 % distortion Verify the RECEIVE SENSITIVITY Baud rate : 200 meter to J3.
Page 17
• MAIN unit Reference frequency adjustment Decode check point Reference frequency check point • ANT unit Receive sensitivity check point Antenna peak adjustment for EP3 Antenna peak check point Antenna peak adjustment for EP4 Antenna peak pre-setting RF input Receive sensitivity Decode 4 - 5...
Page 28
SECTION 7 SEMI-CONDUCTOR INFORMATION • TRANSISTOR AND FET’S 2SA1162 GR 2SA1213 Y 2SA1576 R 2SC2712 GR 2SC3326 B (Symbol: SG) (Symbol: NY) (Symbol: FR) (Symbol: LG) (Symbol: CCB) 2SC4081 R 2SD1664 Q 3SK131 K DTC144 EU (Symbol: BR) (Symbol: DAQ) (Symbol: V13) (Symbol: 26) •...
Page 29
SECTION 8 BOARD LAYOUTS 8-1 FP-561 8-1-1 SW UNIT • TOP VIEW 8 - 1...
Page 30
• BOTTOM VIEW BEEP to LOGIC unit J3 8 - 2...
Page 31
8-1-2 LOGIC UNIT • TOP VIEW to MAIN unit J1 R151 IC44 R132 IC28 R131 R147 IC21 IC20 IC22 R148 R135 R163 R178 R164 IC34 IC31 BLUE IC33 GREEN CONT GPSI GPSO IC35 VBAK IC30 VANT R165 to GPS unit DTCK IC32 VSYNC...
Page 38
• BOTTOM VIEW TUNE ANT V AF GND to MAIN unit J2 to MAIN unit J1 8 - 10...
Page 39
SECTION 9 BLOCK DIAGRAM 9-1 FP-561 DISP UNIT SW UNIT POW SW MAIN UNIT FLASH ROM DRAM SRAM BEEP IC28: SC-1372 IC32, IC33: IC34, IC35: IC30, IC31: MBM29F800BA-90PFTN M5M44260CJ M5M51008BVP-70LL DATA BUS VSYNC HSYNC DCLK R.G.B RL0–RL5 SL0–SL2 ADD BUS...
Page 40
9-2 RD-200 ANT UNIT MAIN UNIT RX_f=283.5~325.0 kHz Q1, Q2: 2SK209 GR Q5, Q6: 2SK209 GR Q3, Q4: 2SK209 GR Q7, Q8: 2SK209 GR IC2: ND487C1 3R LIMIT IC1: UPC1676G Q1: 3SK131K FI1: CFJ455K8 IC4: NJM2904M IC3: TA31136FN 1Lo=738.5~780.0 kHz 456.2 kHz IC6: SC-1287 14.5984 MHz...
Page 41
SECTION 10 VOLTAGE DIAGRAM 10-1 FP-561 RSSI RSSI MAIN UNIT LOCONT LOCONT TXTRG TXTRG TXSIG TXSIG 4.3 Vp-p 5.0 Vp-p D3 1N4002 DA204U IC2D 1SS355 2SC2712 GR FS30KMJ-3 TC4093BF R105 TO-46 10 k SPDOUT R5 4.7 k D30 1N4002 IC7A...
Page 42
LOGIC UNIT DEPCONT DEPCONT 32 MHz 15 k DSO-49SJ R155 CARD 8.2 k R156 15 k 15 k DELAY 15 k NPOR NIOW MPOE R131 OEDS 10 k 15 k 15 k R162 15 k 15 k CABV 15 k 15 k 15 k SABV...
Page 43
SW UNIT 12 V R155 R165 8.2 k SML-310MT SML-310MT SML-310MT R131 to LCD 10 k HSYNC HSYNC SKQDPB SKQDPB SKQDPB VSYNC SML-310MT SML-310MT SML-310MT VSYNC DTCK DTCK 1SS355 1SS355 1SS355 SML-310MT SML-310MT SML-310MT SKQDPB SKQDPB SKQDPB 47 k 0.001 2SC2712 GR 2SC2712 GR 2SC2712 GR...
Page 44
LOGIC UNIT SW UNIT DEPCONT DEPCONT 32 MHz 15 k DSO-49SJ 12 V R155 R165 CARD 8.2 k R156 15 k 15 k DELAY NPOR 15 k SML-310MT SML-310MT SML-310MT NIOW MPOE R131 OEDS 10 k to LCD 15 k 15 k R162 HSYNC...
Page 45
10-2 RD-200 • ANT UNIT 1.2 k 3.3 k 3.3 k 47 P LS-529 47 P to MAIN 220 P unit J1 47 P 3.3 k 0.001 10 k MA2SV05 2SK209 GR EP3-2 0.3 V 2SK209 GR 47 P 100 k 680 k MA2SV05 MA2SV05...
Page 46
• MAIN UNIT 4.8 V 100 H 680 H 0.01 180 P 10 k TA31136FN 10 k PC1676G OSCIN MIXIN 4.6 V OSCOUT CFJ455K8 MIXOUT N-REC 47 k 15 H 18 H 0.001 8.2 H 15 H 0.018 0.018 N-DET to ANT IC4A IC4B...
Page 47
290-294 Albert Street, Brunswick, Victoria, 3056, Australia : http://www.icomuk.co.uk Phone : 03 9387 0666 Fax : 03 9387 0022 : http://www.icom.net.au Zac de la Plaine, Rue Brindejonc des Moulinais BP 5804, 31505 Toulouse Cedex, France 6F No. 68, Sec. 1 Cheng-Teh Road, Taipei, Taiwan, R.O.C.
Need help?
Do you have a question about the FP-561 and is the answer not in the manual?
Questions and answers