How To Use - Sunbeam SR8700 Instruction Booklet

Using your Pro Glide
Using your iron
1.Insert the plug into a 230/240 volt
power outlet and turn the power on.
2.Select the power button to turn the
unit on. The Power On icon illuminates
WHITE as shown in Fig 1, and the unit
beeps once. The boiler and soleplate
will begin heating and the Steam
Ready light illuminates RED.
Figure 1
3.Turn the temperature dial on the
iron to the desired setting (set the
temperature to Silk or above when
using steam). The thermostat light
(as shown in Fig 2) will illuminate
AMBER to indicate that the iron is
heating. It will go out once the iron
has reached the selected temperature.
Figure 2
NOTE: When changing the temperature
dial from a higher setting to a lower
setting, ensure the iron temperature is
8
Plus 8700 Steam Generator (continued)
®
stable at the new setting by allowing the
thermostat to cycle once (the thermostat
light will turn on / off once).
4.Select the desired steam level by
turning the Steam Rate Dial to the
desired setting (as shown in
Fig 3).
NOTE: To prevent water dripping from the
soleplate, only use the steam function
when the temperature of the soleplate is
set to Silk or above.
5.When the steam selection illuminates
GREEN, the unit is ready to use.
NOTE: The Steam Ready light will
illuminate GREEN when the steam
can be activated, usually after 2 1/2
minutes. However, it may take a bit
longer for the steam to be at maximum
power depending on the volume of
water in the boiler and the tank and the
ambient temperature of the water.
Before using the steam generator on
a garment, direct a shot of steam
into the air to release any remaining
condensation.
Figure 3
Figure 4