68 resilium shot & spray iron with safety auto-off; 66 stainless shot & spray iron with safety auto-off; 65 platinum shot & spray iron with safety auto-off; 62 platinum shot & spray iron (12 pages)
Summary of Contents for Sunbeam Ultura 90 Resilium
Page 1
Ultura Irons Instruction Booklet This book covers the use and care of the following Ultura Irons: SR5990 Ultura 90 Resilium Shot & Spray Iron with Safety Auto-Off ® SR5880 Ultura 80 Stainless Shot & Spray Iron with Safety Auto-Off SR5770 Ultura 70 Platinum Shot &...
Contents Sunbeam’s Safety Precautions Features of your Ultura Iron Using your Ultura Iron The Safety Auto-Off Feature Care and Cleaning of your Ultura Iron Ultura Ironing Tips & Tricks Ironing Chart Important instructions – retain for future use.
• Never leave an appliance unattended while in use. If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood.
Resilium is a durable, scratch resistant surface that ® provides a superior glide and prevents rucking. Exclusive to Sunbeam, this premium soleplate features 98 steam holes to maximise steam distribution. 2400W Fast heat up (SR5990, SR5880 & SR5770) Stainless steel soleplate...
Page 5
Variable steam The six-position steam dial allows you to select the desired steam output for each garment. Alternatively, Safety auto-off select the DRY setting to iron without steam. The iron automatically switches itself off if left in the ironing position (horizontal) for 30 seconds, or in the Removable steam valve heel rest position (vertical) for 15 minutes.
Follow steps 1 and 2 above. affecting the steam performance. However in NOTE: When steam ironing, ensure that the very hard water areas, Sunbeam recommends temperature dial is set to any temperature the use of distilled water, or water which has within the steam band, and that the tank been demineralised.
Using your Sunbeam Ultura Iron (continued) Using the shot of steam Using the spray mist The shot of steam can be used when dry The spray mist can be used whether dry or or steam ironing, when the temperature dial...
Care and Cleaning After each use Cleaning the steam holes 1 Turn the STEAM/DRY dial to DRY. To remove build up from the steam holes which may affect steam performance, 2 Turn the power off and remove the plug use a cotton wool tip moistened in from the power outlet.
Ultura Ironing Tips and Tricks Tip # 27 - Iron shirts like a pro Tip # 13 - Ironing the seam Start with the collar, working from the outer Always press seams in the same direction edges into the middle. Iron the shoulder they were made.
Ironing Chart FABRIC TEMPERATURE SETTING IRONING RECOMMENDATION Acrylic • Dry iron on wrong side. Acetate • Dry iron on wrong side while still damp or use spray to dampen. Nylon • Iron on wrong side while still damp or use spray to dampen.
Page 11
You are also Alternatively, you can send a written claim entitled to have the goods repaired or to Sunbeam at the address listed below. replaced if the goods fail to be of acceptable On receipt of your claim, Sunbeam will...
Page 12
Sunbeam Corporation Limited 1999, 2002, 2007. ABN 45 000 006 771 Units 5 & 6, 13 Lord Street Botany NSW 2019 Australia Unit 3, Building D 26 Vestey Drive Mt Wellington Auckland New Zealand 8/11 Sunbeam Corporation is a division of GUD Holdings Ltd.
Need help?
Do you have a question about the Ultura 90 Resilium and is the answer not in the manual?
Questions and answers