68 resilium shot & spray iron with safety auto-off; 66 stainless shot & spray iron with safety auto-off; 65 platinum shot & spray iron with safety auto-off; 62 platinum shot & spray iron (12 pages)
Page 1
Verve Verve Irons Irons ® ™ Instruction Booklet Instruction Booklet This book covers the use and care of the following Verve This book covers the use and care of the following Verve Irons: Irons: ™ ™ SR6800 Verve SR6800 Verve ®...
Contents Sunbeam’s Safety Precautions Features of your Verve Iron Using your Verve Iron The Safety Auto-Off Feature Care and Cleaning of your Verve Iron Ironing Tips & Tricks Ironing Chart Important instructions – retain for future use.
• Never leave an appliance unattended while in use. If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood.
It simply wipes clean for fuss free maintenance. Exclusive to Sunbeam, this premium soleplate features 172 steam holes to maximise steam distribution.
Page 5
Safety auto-off The iron automatically switches itself off if left in the ironing position (horizontal) for 30 seconds, or in the heel rest position (vertical) for 15 minutes. (For more information on the safety auto off feature see page 7). Power light Illuminates to indicate that the iron is connected to the power outlet and the power...
3. Turn the steam dial to the desired affecting the steam performance. However in steam setting. very hard water areas, Sunbeam recommends the use of distilled water, or water which has been demineralised. For best performance, we recommend the use...
Using your Sunbeam Verve Iron (continued) Dry ironing Note: If the tank has run dry, it may be necessary to re-prime the pump after filling Follow steps 1 and 2 above. the iron with water. 3. Select DRY on the steam dial.
Care and Cleaning After each use Cleaning the steam holes 1. Turn the power off and remove the plug To remove build up from the steam holes which may affect steam performance, from the power outlet. use a cotton wool tip moistened in 2.
Ironing Tips and Tricks Tip # 27 - Iron shirts like a pro Tip # 13 - Ironing the seam Start with the collar, working from the outer Always press seams in the same direction edges into the middle. Iron the shoulder they were made.
Ironing Chart Fabric Temp setting Ironing Ironing recommendation MINIMUM Acrylic Dry iron on reverse side of fabric Min to • MINIMUM Dry iron on reverse side of fabric Acetate while still damp Min to • MINIMUM Nylon Iron on reverse side of fabric Min to •...
Page 11
You are also entitled to have the goods written claim repaired or replaced if the goods fail to be to Sunbeam at the address listed below. of acceptable quality and the failure does On receipt of your claim, Sunbeam will...
Page 12
Sunbeam Corporation Limited 2011. ABN 45 000 006 771 Units 5 & 6, 13 Lord Street Botany NSW 2019 Australia Unit 3, Building D 26 Vestey Drive Mt Wellington Auckland New Zealand Sunbeam Corporation is a division of GUD Holdings Ltd. 6/11...