Setting The Ch3/Ch4 Switch - Hitachi VT-MX4410A Owner's Manual

PREPARATION FOR USE
Fig. 6:
This connection is good only if none of your channels are scrambled. You can record
one channel while viewing another. Scrambled channels can not be recorded with this
connection.
RECORDING HINTS
1) Be sure to check that the POWER and the VCR/TV indicators are both on.
2) Turn on the TV and Cable Box.
3) Set the channel to be recorded on the VCR.
4) Set the TV and Cable Box to channel 3 or 4.
5) Set the CH3/CH4 switch on the back of the VCR to match the channel set on the TV.
6) To view ONE channel while recording ANOTHER, the VCR/TV indicator must be off.
For AUTOMATIC TIMER RECORDING, the VCR/TV indicator must be off after step
[11] on page 25.
7) Set the channel to be viewed on the Cable Box.
Note: If you wish to see the VCR menu, view what you are recording or playing a tape
with this connection, the VCR/TV indicator must be on and the Cable Box channel must
match the channel selected on the back of the VCR. (CH3 or 4) .
Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to Article 820-40
of the NEC that provides guidelines for proper grounding and, in particular, specifies
that the cable ground shall be connected to the grounding system of the building, as
close to the point of cable entry as practical.

SETTING THE CH3/CH4 SWITCH

If your TV does not have A/V terminals:
When the VCR is in the Playback mode or when the VCR is in the VCR position, your
TV will receive the signals from the VCR on either channel 3 or 4.
To use the VCR with your TV, set the selector switch to CH3 or CH4, (which is located
in the back of your VCR), whichever is not used for normal broadcasts in your area.
Then set your TV to that same channel.
23