Hitachi VT-MX4410A Owner's Manual page 52

RECORDING
(SP/SLP).
3 Begin IRT
Press REC/IRT button on the VCR as many times as needed. The recording length will
be determined by the number of times you press REC/IRT button.
Each additional push will increase the recording time by 30 minutes. It can be set for up
to 8 hours.
IRT (1:30)
SP
• Recording starts immediately when the REC/IRT button is pressed, whether you are
watching the same or a different channel.
• When REC/IRT button is pressed 18 times, the VCR returns to the normal recording
mode.
• To stop the IRT operation, press the STOP button on the VCR or on the remote
control.
• To show the remaining time, press the DISPLAY button on the remote control so that
"IRT" appears on the TV screen. (It will show up momentarily then disappear.)
• Recording stops when 0:00 is reached.
• Please note that in the SLP mode maximum recording time, assuming the tape is
started at the beginning, is 8 hours using T-160 (or 6 hours using T-120).
• The TV that is connected to your VCR may be turned on or off during IRT.
• If the tape runs out before the end time, the VCR will switch to the Stop mode
immediately, eject the tape and the VCR power will be turned off.
52