Making the temporary headset connection before connecting
to
power
Plug the special headset connector into the AUX jacks on the rear of the media center (Figure
17). This is for temporary use during steps for "Finishing the installation" on page 21.
Headset connection for use
in the final setup steps
Figure 17
Connecting the
system to
power
Connect the two AC power (mains) cords in the following order:
1.
Plug the small end of the Acoustimass® module power cord into the AC power jack on the
connector panel of the Acoustimass module (Figure 18). Plug the other end of the power
cord into an AC (mains) outlet
2.
Turn the Acoustimass module POWER switch to on ( I ).
Figure 18
Power connection of the
Acoustimass moduler
...... Connector panel
Power switch