AEG ECLIPSE 10 User Manual page 21

13.7 Handset Registration
IMPORTANT: When you purchase your unit, all handsets are already registered to your base, so you do
not need to register them.
Handset registration is only necessary when you buy extra handsets or if a handset has become faulty.
You can register up to four handsets to one base station, with each handset's number (1 to 4) shown on
its display.
Note: Each handset can only be registered to one base.
You need to enter the Master PIN before you can register or deregister handsets. The default Master PIN
is 0000.
13.8 Register Additional Handsets
Press and hold the
>The message indicator on the base will flash for up to 1 minute, while it is in registration mode.
On the handset, press
Press to "SETTINGS" and then press
Press to "REGISTRATION" and then press
Enter the Master PIN and then press
Note: After entering the Master PIN,
>WAITING flashes on the screen.
>A confirmation tone is played to indicate successful registration, and the handset returns to standby
mode, with its handset number displayed.
>If no base is found with the entered PIN, error tones are played to indicate failed registration and
"PLS REG H/S" is displayed on the screen. You will need to repeat from step 1 above.
>During steps 2-5, if no key is pressed on the handset within 10 seconds, the registration procedure will
be aborted. If this happens, repeat from step 1 above.
13.9 Deregister your Handset
You can deregister the handset you are using, or any other handset registered to the same base. The
default Master PIN is 0000.
From the home screen, press
Press to "SETTINGS" and then press
Press to "DEREGISTER" and then press
Enter the Master PIN and then press
Press to select the handset number you want to deregister and then press
press to cancel the deregistration procedure.
Note: After confirming the handset you want to remove:
>A confirmation tone is played to indicate successful deregistration.
>"PLS REG H/S" is displayed on the home screen of the unregistered handset.
>If no handset key is pressed within 10 seconds, the procedure will abort and the handset returns to
standby mode.
key under the base unit for approximately 5 seconds.
.
to confirm.
.
to confirm.
to select.
to select.
to select.
to select.
to confirm, or