AEG ECLIPSE 10 User Manual page 27

14.7.1 Access the Answering Machine Remotely
Dial your phone number from any touch-tone phone.
When your answering machine answers your call and starts playing your announcement, press the # key.
>The announcement will stop playing.
Enter your Remote Access Code (same as your Master PIN code) within 8 seconds using the numeric
keypad on the touch-tone phone.
Note: that the answering machine will drop the call if you do not enter the Master PIN within 8 seconds.
If the code is accepted, you will hear a confirmation tone.
The answering machine will start to playback all the messages on your answering machine, beginning
with new messages, or if there are no recorded messages you will hear four beeps.
Use the keypad on the touch-tone phone to carry out the following operations:
Keys
1 Repeat the previous message.
2 Playback messages / Repeat the current message.
3 Skip to the next message.
6 Delete the current message.
7 Turn on the answering machine in RECORD MSGS mode (main Eclipse handset) or
ANSW.&RECORD mode (additional handsets).
8 Stop message playback.
9 Turn off the answering machine.
When you have finished listening to your messages, simply hang up the phone to end.
Note:
If your answering machine is off but Remote Access is activated ,the answering machine will answer your
call after 14 rings, so that you can access it remotely, and the "ANSWER ONLY" announcement will play.
If you enter an incorrect Remote Access Code, you will hear a triple-beep error tone, and you will need
to enter the code again. If you enter the wrong Remote Code twice consecutively, the call will end
automatically.