Table of Contents
Advertisement
(3)
EDlTiCANCEL key
This key allows you to put the
9000
in the Edit mode. Pressing this key allows you also to
cancel the store and some other operations.
(4)
AMPILINE (PARAMETER) key
In
the
Play mode, this
key allows you to select tone of the
9000
in accordance with the
playback unit used.
In
the Edit mode, this key allows you to call the parameter
to be edited.
(5)
BANK DOWN/ UP key
This key allows you to select the desired
Bank
from Banks 0 to 4. The desired Patch can be
selected by using this key and the
PATCH
key.
(6)
PATCH
1 to 4
key
This key allows you
to
select the desired Patch from the
Bank
currently being selected.
(7)BY PASSTTUNER key
This key allows you to turn off (or bypass) the effect temporarily. This key activatcs the
tuning function when the 9000 is put in the Bypass status.
(8)VALUE
-
/
+
key
In
the
Play mode,
normally, this key allows you to control the master volume.
In
a
Bypass status, this key is used for adjusting the calibration signal to be used as the
reference pitch of the tuner.
0
In
the Edit mode, this key allows you to select the effect type and change the parameter
value currently being selected.
(9)POWER LED
This indicator shows the power-on or power-off status.
' I Zatc:
The flashing
POWER LED
indicates that the batteries are about to run down. When the
POWER
LED
flashes, replace the batteries. The life of the battcries is approximately three
hours for manganese type batteries and six hours for alkaline type batteries (when operated
continuously). To install the lid of the battery case, insert the hook of the lid into the hole, and
then firmly lock the back of the lid in place of the unit.
Advertisement
Table of Contents
