ASSEMBLY INSTRUCTIONS
STEP 7
Slide the SEAT(19) onto the CENTER BEAM(1). Insert the STOPPER BOLT(14) through the CENTER
BEAM(1) and lock in position by screwing on the STOPPER(13). Also, please verify that the other STOPPER
BOLT(14) and STOPPER(13) have already been assembled at the factory. If it has not been pre-assembled,
then please assemble at this time. Press the CENTER BEAM CAP(22) into the back end of the CENTER
BEAM(1).
STEP 8
Pry the METER(39) from the CONSOLE(40). Attach the CONSOLE(40) to the CENTER BEAM(1) with
SCREWS(M4x10mm)(50).
STEP 9
Install an AA battery into the METER(39), one battery included. See page 11 for detailed battery installation
instructions. Run the connection wire of the METER(39) through the square hole on the CONSOLE(40).
Place the METER(39) back into the CONSOLE(40). Plug the connection wire of the METER(39) into the
SOCKET located at the front end of the CENTER BEAM(1).
SOCKET
(Assembled at the factory)
10