Westerbeke 5.0Kw BCDR Operator's Manual page 63

D
GenRemote INSTALLATION DIAGRAM
Note:
GenRemote
Electrical Box
GenRemote uses engine oil pressure
and AC voltage to recognize the
engine is running.
Without AC input the generator will run
and GenRemote will only monitor the
Battery, Water Temp and Oil Pressure.
Westerbeke 8 Wire Harness & Plug
~
J;;
'li
~
~
J;;
E
U)
IOO@]
~
rr-----~~==~~--Jlll~~~~C~k--------~
~ ~~~~~i
ffil
12
In
Whffear
115 vee
~utral
i
~~~~~~~~~
i i
Westerbeke AC Output L 1 & L2
Neutral Not Required
for 220 Volt Applications
No AC readings will be displayed and the
Run Indicator will not tum on.
11
Out
Black
'-12':"O-uf-Wh-H-e--+ To AC Load
L...--""-----+AC Load can be connected
directly to generator, however,
the L 1 and L2 current readings
will not be available.
The AC signal MUST be wired
to GenRemote.
STOP/START ROCKER SWITCH
The One llluminated Button Start / Stop Rocker Switch is provided for areas where remote start stop
functions are required and no space is available for the standard display panel.
Sta rt the generator by pressing and releasing the upperrocker once. The lamp will flicker rapidly while
the generator is starting. The indicator lamp will remain on and steady while the generator is running .
. Stop
the generator by pressing and releasing the lower rocker once.
Trou ble Indicator:
The indicator lamp will flicker slowly while the generatoris operating if a service
problem is developing. Possible problems include,
High
Coolant Water Temperature, Low Oil Pressure
and
High
Exhaust Temperature Safety Switch. .
START
STOP
6 Conductor Data Coble
Maximum Length 150 •
Press Once To Start
L\lh1 Fleshes I10pidlyWliJe
Generotcr Js Starting.
Light Remains On
While
Generator
Is
Operotng
Press Once to Stop
S10w SUnIl.,. light WhIJe
1he Generator
Is
Rmnlng
Inc:llcates SeTVlce Problem
Accessory ~----~
Display 2
Display 1
Engines & Generators
58