Table of Contents
Advertisement
WARNER HYDRAULIC TRANSMISSIONS
FROM
COOLER
10-13/10-14
1.
CONTROL LEVER POSITION
FROM COOLER
(2.10:1 ONLY)
FROM COOLER
10-17/10-18
(EXCEPT 2.10:1)
The position of
the control lever
on transmission when
in forward
should be shifted to the point where it covers the letter "p" on the
case casting,
and
is located
in its proper pOSition by the poppet
ball.
The Warranty is cancelled if the shift lever poppet spring
and/or ball is permanently removed, or
i f
the the control lever
is
changed in any manner, or repositioned, or if linkage between remote
control and transmission shift lever does not have sufficient travel
in both directions.
This does not apply to transmissions equipped
with Warner Gear electrical shift control.
2.
LUBRICATION
The
properties
of
the
1
used
in
the
transmission
are
extremely
important to the proper function of the hydraulic system.
Therefore,
it
is
extremely
important
that
the
recommended
oil,
automatic
transmission fluid (ATF) , Type A or Dexron II be used.
NOTE:
Be
sure
the
cooler
is
properly
installed when required and
the transmission conta
oil before cranking or starting the engine.
27
Advertisement
Table of Contents
