Table of Contents
Advertisement
BeG II.OKW SYSTEM SPECIFICATIONS
Sea Water Flow, at 1800 rpm
(measured before discharging
into exhaust elbow)
System Capacity (fresh water)
LUBRICATION SYSTEM
General
Oil Filter
Sump Capacity (not including filter)
Operating Oil Pressure (engine hot)
Oil Grade
ELECTRICAL SYSTEM
Starting Battery
Battery Capacity
DC Battery Charger
Starter
DC No-Load Current
DC Cranking Current
Westerbeke Generators
3.75 - 11.0 U.S. gpm (14.19 - 15.14Ipm)
3.3 U.S. qts (3.2 liters)
Pressure type by Trochoid pump,
chain-driven through balance shafts.
Full flow, paper element, spin-on type
3,0 qts (2.9 liters)
50 - 70 psi (3.5 - 4.9 kg/cm
2
)
API specification of SD or SE, preferably SF
12-Volt, 26 A-H, (-) negative ground
(recommended) (35 A-H in cold areas)
90 - 125 (Ampere-Hours)
Internal regulator 13 Volts, 0 -10 Amps.
12-Volt, 1.2f<W, reduction type,
solenoid-mounted
90 Amp (max,) at 11.5 Volts.
175 - 200 Amps (engine cold)
12
Advertisement
Table of Contents
