Hitachi CP-X205 User's Manual And Operating Manual page 105

Command Control via the Network
commands.
Communication Port
The following two ports are assigned for the command control.
NOTE
9
(
Example: If the IP address of the projector is set to 192.168.1.10:
1) Enter "http://192.168.1.10/" into the address bar of the web browser.
[Port Settings] on the main menu.
4) Click the [Enable] check box to open
authentication is required, otherwise clear the check box.
[Enable] check box to open
when authentication is required, otherwise clear the check box.
[Apply] button to save the settings.
[Enable] check box for the [Authentication] setting when
[Enable] check box for the [Authentication] setting
[Logon].
to use
to