Sanus Systems STEEL FOUNDATIONS SFC Instruction Manual page 2

PHOTO 1
a
f
g
e
n
i
Important: This product uses two
different feet for each base. Before
installing, be sure to check that the
feet are mounted with the (1) foot
on the front left and rear right of
the base, (2) front right and rear
left. The designation (1) & (2) are
on the bottom of each foot.
Page 2
d
b
h
k
j
c
l
Hardware List
(PHOTO 1)
a) isolation block - 1
b) 1-1/2" pan head bolt - 2
c) lock washer - 2
d) rubber isolation pad - 8
e) plastic foot - 4
f) 5/8" pan head bolt - 4
g) carpet spike - 4
h) machine nut - 8
i) allen key - 1
j) threaded stud - 2
k) rubber stud cover - 2
l) cork damping washer - 2
m) wire guide - 2
n) flat head bolt - 2
ʻTake the time to find the right speaker locations for your
listening room.ʼ
1] Attach the plastic feet (e) to the
corners of the base with the small pan
head bolts (f). Photo 2-Group two pillars
with the base. Align the holes in the base
with the holes in the isolation block (a).
Bolt the pillars and the base together
with the isolation block between them
using the large pan head bolts (b) and
lock washers (c). Photo 3-Using the
wire guide is optional.
2] Adhere the two inch self-adhesive damping washers (l) to the flush
side of each top plate. The damping washers will be set in between the
top plate and the pillars. (Optional: You may fill the pillars with sand
or shot at this time.) Align the holes in the top plate with corresponding
m
holes in the top of each pillar. Bolt the pillars and the top plate together
using the flat head bolts(n). Photo 4-The wire guide (m) is optional.
3] Both spiked feet (g) and rubber feet (d) are provided for your Steel
Foundations®. The spiked feet are preferable in terms of performance.
Thread a machine nut (h) over the
spiked feet and thread the ends of the
spiked feet into the threaded inserts in
the corner feet. Adjust the spiked feet
until the stand is level and then lock
into place by tightening the machine
nut. Use of the spiked feet is optional.*
The rubber feet are provided as an
alternative.
* PLEASE READ THE NOTE ON PAGE 4 OF THIS MANUAL!
Page 3
Photo 2
Photo 3