Cellular Configuration Screen (3G) - ZyXEL Communications ZyWALL USG 50 User Manual

Table 59 Configuration > Network > Interface > PPP > Add (continued)
LABEL
Related Setting
Configure
WAN TRUNK
Policy Route
OK
Cancel

11.5 Cellular Configuration Screen (3G)

3G (Third Generation) is a digital, packet-switched wireless technology. Bandwidth
usage is optimized as multiple users share the same channel and bandwidth is
only allocated to users when they send data. It allows fast transfer of voice and
non-voice data and provides broadband Internet access to mobile devices.
Note: The actual data rate you obtain varies depending on the 3G card you use, the
signal strength to the service provider's base station, and so on.
You can configure how the ZyWALL's 3G device connects to a network (refer to
Section 11.5.1 on page
• You can set the 3G device to connect only to the home network, which is the
network to which you are originally subscribed.
• You can set the 3G device to connect to other networks if the signal strength of
the home network is too low or it is unavailable.
ZyWALL USG 50 User's Guide
DESCRIPTION
Click WAN TRUNK to go to a screen where you can configure the
interface as part of a WAN trunk for load balancing.
Click Policy Route to go to the screen where you can manually
configure a policy route to associate traffic with this interface.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
245):
Chapter 11 Interfaces
243