Connect Vent - Whirlpool 27" ELECTRIC WASHER/DRYER Installation Instructions Manual

CONNECT INLET HOSES
6.
Check for leaks
Turn on water faucets to check for leaks. A small amount of
water may enter washer. It will drain later.
7.
Secure drain hose
Laundry Tub Standpipe
4.5"
4.5"
4.5"
4.5" 4.5"
(114 mm)
(113 mm)
(114 mm)
(113 mm) (113 mm)
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with shipping strap removed earlier.
22

CONNECT VENT

Wall
4.5" 4.5"
4.5"
(113 mm) (113 mm)
(114 mm)
1.
Connect vent to exhaust outlet
Connecting from front
(for closet or recessed
area)
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is
clean. Dryer vent must fit over dryer exhaust outlet and inside
exhaust hood. Check that vent is secured to exhaust hood
with a 4" (102 mm) clamp.
2.
Move washer/dryer to final location
Move washer/dryer to final location, taking care not to crush
or kink vent.
After washer/dryer is in place, remove corner posts and
cardboard from under washer/dryer.
Connecting
from rear