Connect Vent - Whirlpool MET3800XW0 Installation Instructions Manual

CONNECT INLET HOSES
Check for leaks
C
CONNECT ¥ NT
Connect vent to exhaust outlet
o
©
©
Turn on water faucets to check for leaks. A small amount of
water may enter washer. It will drain later.
Secure drain hose
Standpipe
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with shipping strap removed earlier.
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is
clean. Dryer vent must fit over dryer exhaust outlet and inside
exhaust hood. Check that vent is secured to exhaust hood
with a 4" (102 mm) clamp.
2. Move washer/dryer to final location
Move washer/dryer to final location, taking care not to crush
or kink vent.
After washe/dryer is in place, remove corner posts and
cardboard from under washer/dryer.
22